50% OFF on ALL PRODUCTS for Limited Time Only | Apply Code "CLOSEOUT50" at Checkout | $9.99 Flat-Rate Shipping Worldwide


Your Cart is Empty

October 04, 2019 2 min read

Backflow Incense Cones

Physically, cone incenses are completely different to stick (cylinder) incenses.

Stick incense is equally distributed thus once lit up; its burn time is stable from prime to rock bottom. reckoning on the manufacturer, its weight and size might vary. 


Backflow Incense Cone is made from powder, molded into cone or bud shape. Beneath all-time low of the cone may be a little hole for the smoke of the burned incense to falling down rather than rising high as different ancient incense varieties. You can make your own backflow cones out of any incense cone you want by drilling a very small hole in the middle of the cone from the bottom almost to the top. You'll need to make sure to hold the cone firmly and go slowly so it doesn't crumble while drilling. Incense smoke, if burned regularly and in large amounts, may be bad for your health, just like inhaling any type of smoke would be. The best way to keep incense from decreasing the quality of air in your home is to burn it as sparingly as possible.



Backflow incense cones, The smoke flows downwards in a backflow burner! An exotic, earthy fragrance with subtle notes of pine needle, Arabian sandalwood, musk, and amber. Ocean Wind Backflow Cones. And when you consider that each cone can burn for approximately ten minutes, it means the package will last for many hours. If the top is within the jigger, smoke can build up in there and may be poured out. Smoke is heavier than air however usually floats upwards as a result of it's hot. The tube gives the smoke enough time to cool down, after which it doesn't rise up, but instead falls to the floor like a waterfall. The raw materials are small-grained so mixed at the side of a binder to create a paste, which, for direct burning incense, is then cut and dried into pellets. Incense of the Athonite Orthodox Christian tradition is created by powdering thus or fir rosin, intermixture it with essential oils.




Burning Incense Cones:

1.         Light the tip of the incense cone.

2.         Gently extinguish the flame by blowing or fanning.

3.         Place on/in a cone burner with the point facing up or in a bowl burner on a bed of sand or natural ash.


Burning Tips: If the cone goes out, it's going to not be obtaining enough elements to stay it burning. this might happen if your burner is just too little. If your burner contains a lid, strive to remove it. 

Always store your cones during a cool dry place. If they devour an excessive amount of wetness they're going to not burn properly. otherwise you could have a poor quality incense.


Leave a comment

Comments will be approved before showing up.